Enclosure volume for DIY speakers

Drivers need enough air behind them, and the battery and amp take some of it. Measure the inside of the box, then subtract what you put in it.

Calculate it

Internal volume in litres = length × width × height in centimetres ÷ 1000. A box 25 × 17 × 12 cm inside is 5.1 L. In inches, multiply length × width × height by 0.016387. Subtract the battery (a 4S2P 18650 pack is about 0.3 L), the amp and wiring (about 0.1 L), and about 0.15 L per driver magnet. The planner assumes 1.5 L for electronics and wiring, which is conservative, and for molded cases it also applies an 85% usable-volume factor to the published rectangular interior, to allow for ribs, corner radii and draft.

Common case sizes

CasePublished interiorUsable (× 0.85)Source
Pelican 12004.5 L (9.31 × 7.13 × 4.12 in)3.8 Lpelican.com
M2A1 .50 cal ammo can6.9 L (11 × 5.5 × 7 in)5.9 LCommon retailer listing; verify your can
Pelican 14008.9 L (11.81 × 8.87 × 5.18 in)7.6 Lpelican.com
Apache 28009.3 L (11.88 × 9.00 × 5.31 in)7.9 LDataPro
Pelican 145015.0 L (14.66 × 10.24 × 6.12 in)12.8 Lpelican.com
Apache 380015.9 L (14.88 × 10.63 × 6.13 in)13.5 LDataPro
Apache 480023.2 L (17.88 × 12.88 × 6.13 in)19.7 LDataPro
Pelican 155033.4 L (18.63 × 14.18 × 7.72 in)28.4 Lpelican.com

Published litres use the manufacturer’s (or DataPro’s) listed interior length × width × depth. Interiors taper and have corner radii, so measure your own case. Harbor Freight lists the Apache 4800’s inside height as 6-5/8 in, which is a little taller than DataPro’s 6.13 in.

Sealed or ported

Small full-range builds are usually sealed: simpler, tighter bass and less to get wrong. A ported box adds output near its tuning frequency but needs the port length calculated for the box volume and driver.

3D printed enclosures

Print with 4 or more perimeters at 3 to 4 mm wall thickness so the panels don’t resonate. Use PETG or ASA: PLA softens around 55 to 60 °C, which a closed car can reach. Add heat-set inserts for screws, a foam or silicone gasket on the lid, and seal seams so the box is airtight. Large boxes can be split into panels to fit the print bed. Useful items: PETG filament, heat-set inserts.

Open the build planner