Build a Bluetooth speaker in an Apache case

Apache and other Pelican-style protective cases make rugged, sealed speaker enclosures. The Apache 2800’s published interior is about 9.3 L (11.88 × 9.00 × 5.31 in, DataPro). The Apache 3800 is about 15.9 L (14.88 × 10.63 × 6.13 in). The planner treats about 85% of that published rectangular volume as usable, to allow for ribs, corner radii and draft. Always measure your own case.

Starter parts

Two 4 in full-range drivers rated 30 W, a 2×50 W Bluetooth amp board, a 4S 18650 pack, a USB-C charge port, a panel switch, a fuse, speaker terminals or soldered leads, and damping foam. Check all of it against each other in the planner first. Useful items: Apache 3800, step drill bit, gasket tape.

Steps

1. Lay out the front. Place drivers on the lid or a long side, with clearance for the frame and for the magnet depth inside. Mark centers with tape and a ruler.

2. Cut the openings. Drill a pilot hole, then enlarge it with a step bit or hole saw. Cut slightly under size and test-fit. Deburr the edges.

3. Mount the drivers. Apply gasket tape under each frame and secure with machine screws and nuts so the seal is airtight.

4. Seal the case. Fill unused holes, and keep the case’s own gasket intact. A pressure equalizing vent helps if you’ll travel by air or climb in altitude.

5. Place electronics. Mount the amp and battery on foam or standoffs. Line the walls with damping material. Keep the antenna area clear of metal.

6. Wire it. Battery positive goes through the fuse and switch to the amp. Keep power leads short and thick, and match speaker polarity.

7. Test. Check voltage with a meter before connecting. Play at low volume first, then listen for buzzing and check that nothing gets hot.

Battery safety: use a BMS pack, a matching charger and a fuse, and keep cells from being punctured. See the battery sizing guide.

Open the build planner